2005

10 | Chapter 1 Wires
Trimming Wires
After you insert wires, you may need to trim them. The Trim Wire tool
removes wire segments. You can trim single or multiple wires.
To trim a wire
1 Click the Trim Wire tool.
Menu Wires ➤ Trim Wire
2 Respond to the prompts as follows:
Fence/Zext/<Select wire to TRIM>:
Specify the wire segment at line reference 404 between the two vertical wires (1)
Wire segments are trimmed back to a connecting dot, a component, or
completely if neither is encountered along the segment. Any connection
dots that are no longer needed are removed.
The trimmed wire resembles the following image:
This is the end of this tutorial chapter.
1