2009

■ On the command line, enter near, press ENTER, and select a point on the underside of the
bond beam, perpendicular to the upper left corner of the window head.
■ On the application status bar, turn on Object Snap.
■ Move the cursor to the lower left endpoint of the bond beam, and click to place the channel.
■ Select the lower left endpoint of the channel that you just placed, move the cursor up, and
select the upper left endpoint of the second concrete masonry block.
■ Press ESC.
9 Add gypsum wall board to the detail:
■ On the Getting_Started tool palette, click the GWB [19mm Gypsum Wallboard] tool.
■ At the bottom of the detail, select the lower right endpoint of the horizontal hat channel.
■ Move the cursor to the left, and select the lower left endpoint of the vertical hat channel.
Detailing Your Design | 39