2009

■ On the command line, enter x (X flip) [y (Y flip)], press ENTER, and position the angle as
shown.
If you are creating the metric detail, you may need to adjust the position of the angle.
■ Press ESC.
7 Add a window head to the detail:
■ On the Getting_Started tool palette, click the Storefront Head at Finish [115mm Shopfront
Head at Finish] tool.
■ On the application status bar, click (turn off Object Snap), move the cursor until the
right side of the window head aligns with the bottom right of the angle, and click to place
it.
■ Press ESC.
8 Add hat channels to the detail:
■ On the Getting_Started tool palette, click the 7/8'' Hat Channel [22mm Hat Channel] tool.
■ On the Properties palette, for View, select Elevation.
38 | Chapter 1 Getting Started