2009

■ Move the cursor over the endpoint shown.
■ On the command line, enter y (Y flip), press ENTER, and click to place the bond beam.
■ Press ESC.
5 Add a concrete masonry block course above the bond beam in the detail:
■ On the Getting_Started tool palette, click the 6'' x 8'' x 8'' CMU [140 x 200 x 400mm Block]
tool.
■ On the command line, enter c (Count) to insert a course, and press ENTER.
■ Enter 2 to specify the number of blocks in the course, and press ENTER.
■ Select the upper right endpoint of the bond beam, and place the lower right corner of the
course.
■ Move the cursor up, and click to place the course.
■ Press ESC.
6 Add a steel angle to the detail:
■ On the Getting_Started tool palette, click the L4x3.5x0.375 angle [Lintel] tool.
■ Move the cursor over the lower right endpoint of the bond beam.
Detailing Your Design | 37