2008

■ Select the lower-left endpoint of the wall board that you just placed, enter y (Y flip), press ENTER, move
the cursor up, and select the top left endpoint of the vertical hat channel.
■ Press ESC.
10 Detach the section view that you referenced to create the detail.
■ On the drawing window status bar, click .
■ On the External References palette, under File References, click Building Section.
■ Right-click, and click Detach.
■ Close the External References palette.
11 Create a new model space view for the detail with an appropriate scale:
■ On Project Navigator, under Views, select Window Detail, right-click, and click New Model Space View.
■ On the Add Model Space View worksheet, click the Name field, and enter Window Detail@Head.
■ For Scale, select 1 1/2'' = 1'0'' [1:10].
■ On the right side of the worksheet, click , and draw a window selection around the detail.
■ In the Add Model Space worksheet, click OK.
■ In the Project Navigator, under Window Detail, open the new Window Detail@Head view.
12 Add a cut line to the detail:
■ On the Project Navigator, click Window Detail@Head to display the extents of the model space view.
■ On the application status bar, turn ORTHO on.
■ On the Getting_Started tool palette, click the Cut Line tool.
■ Specify a point to the left of the second CMU in the detail, but within the extents of the model space
view.
■ Move the cursor to the right side of the detail, and specify an endpoint for the cut line.
38 | Chapter 1 Getting Started