2008

■ Turn off OSNAP, move the cursor until the right side of window head aligns with the bottom right of
the angle, and click to place it.
■ Press ESC.
8 Add hat channels to the detail:
■ On the Getting_Started tool palette, click the 7/8'' Hat Channel [22mm Hat Channel] tool.
■ On the Properties palette, for View, select Elevation.
■ On the command line, enter near to, and select a point on the underside of the bond beam,
perpendicular to the upper-left corner of the window head.
■ Move the cursor to the lower-left endpoint of the bond beam, and click to place the channel.
■ Select the lower-left endpoint of the channel that you just placed, move the cursor up, and select the
upper-left endpoint of the second CMU.
■ Press ESC.
9 Add gypsum wall board to the detail:
■ On the Getting_Started tool palette, click the GWB [19mm Gypsum Wallboard] tool.
■ At the bottom of the detail, select the lower-right endpoint of the horizontal hat channel.
■ Move the cursor to the left, and select the lower-left endpoint of the vertical hat channel.
Detailing Your Design | 37