2008

■ Press ESC.
5 Add a CMU course above the bond beam in the detail:
■ On the Getting_Started tool palette, click the 6'' x 8'' x 8'' CMU [140 x 200 x 400mm Block] tool.
■ On the command line, enter c (Count) to insert a CMU course.
■ Enter 2 to specify the number of CMUs in the course, and press ENTER.
■ Select the upper-right endpoint of the bond beam, and click to place the lower right corner of the
CMU course.
■ Move the cursor up, and click to place the course.
■ Press ESC.
6 Add a steel angle to the detail:
■ On the Getting_Started tool palette, click the L4x3.5x0.375 angle [Lintel] tool.
■ Move your cursor over the lower right endpoint of the brick course.
■ On the command line, enter x (X flip) [y (Y flip)], press ENTER, and position the angle as shown.
If you are creating the metric detail, you may need to adjust the position of the angle.
■ Press ESC.
7 Add a window head to the detail:
■ On the Getting_Started tool palette, click the Storefront Head at Finish [115mm Shopfront Head at
Finish] tool.
36 | Chapter 1 Getting Started