2008

■ Zoom in around the top of the first floor window on the right exterior wall.
3 Begin detailing by adding a course of bricks to the view:
■ On Getting_Started tool palette, click the Standard Brick - 3/8'' Jt [Standard Brick - 10mm] tool.
■ On the application status bar, verify that ORTHO and OSNAP are on, and an endpoint osnap is selected.
■ On the command line, enter c (Count) to insert a course of bricks.
■ Enter 10 to specify the number of bricks in the course, and press ENTER.
■ Select the endpoint shown below to place the lower-left corner of the brick course.
■ Move the cursor up, and click to place the course.
■ Press ESC.
4 Add a bond beam to the detail:
■ On the Getting_Started tool palette, click the 6'' x 8'' Bond Beam [Bond Beam 150 x 200] tool.
■ Move your cursor over the endpoint shown.
■ On the command line, enter y (Y flip), press ENTER, and click to place the bond beam.
Detailing Your Design | 35