2008

■ Select the black linework that represents the interior partition walls, and press ENTER.
■ On the command line, enter y, and press ENTER.
■ On the Properties palette, under Dimensions, for Base height, enter 9' [3000 mm].
■ For Justify, select Center.
■ Press ESC to hide the interior wall grips.
The interior walls display on the floor plan and clean up automatically with the exterior walls.
Now that the walls are complete, you can add doors and windows. When you add doors and windows,
you can center them in walls, offset them specific distances from other walls on the plan, or place them
freely. Both windows and doors automatically attach to the wall in which you insert them and trim
automatically.
6 If necessary, turn on dynamic input to display dimensions as you insert doors and windows:
■ On the application status bar, click DYN to turn it on.
7 Center a double door in the wall between the corridor and the reception area:
■ On the Getting_Started tool palette, click the Hinged - Double - Full Lite door tool.
■ On the Properties palette, under Dimensions, for Standard sizes, select 5'-0'' X 7'-0'' [1500 mm X 2000
mm].
■ Under Location, for Position along wall, select Offset/Center.
■ Select the vertical wall between the corridor and the reception area, and move the cursor along the
wall.
Laying Out a Floor Plan | 17