User`s guide
Table Of Contents
- Introduction
- Chapter 1: Taking the AutoCAD Tour
- Chapter 2: Creating Basic Drawings
- Chapter 3: Manipulating Objects
- Lesson: Selecting Objects in the Drawing
- Lesson: Changing an Object's Position
- Lesson: Creating New Objects from Existing Objects
- Lesson: Changing the Angle of an Object's Position
- Lesson: Creating a Mirror Image of Existing Objects
- Lesson: Creating Object Patterns
- Lesson: Changing an Object's Size
- Challenge Exercise: Grips
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
- Chapter 4: Drawing Organization and Inquiry Commands
- Chapter 5: Altering Objects
- Lesson: Trimming and Extending Objects to Defined Boundaries
- Lesson: Creating Parallel and Offset Geometry
- Lesson: Joining Objects
- Lesson: Breaking an Object into Two Objects
- Lesson: Applying a Radius Corner to Two Objects
- Lesson: Creating an Angled Corner Between Two Objects
- Lesson: Changing Part of an Object's Shape
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
430 ■ Chapter 5: Altering Objects
4.
To complete the stretch operation:
■ Click to select near the bottom corner of
the wall and drag the cursor to the left 180
degrees.
■ Enter 2000. Press ENTER.
■ Notice that the dimensions also update to
reflect the new size.
5.
To use stretch with a Crossing Polygon
selection:
■ Press ENTER to repeat the Stretch
command.
■ Enter CP to specify a crossing polygon
selection. Press ENTER.
■ Define the crossing polygon by clicking
points, as shown in the following image.
6.
To add 2000 units to the right side of the
structure:
■ Press ENTER to complete the crossing
polygon selection.
■ Press ENTER to complete the object
selection.
■ Click a point near the bottom corner of the
wall.
■ Drag your cursor to the right at 0 degrees
and enter 2000. Press ENTER.