User`s guide
Table Of Contents
- Introduction
- Chapter 1: Taking the AutoCAD Tour
- Chapter 2: Creating Basic Drawings
- Chapter 3: Manipulating Objects
- Lesson: Selecting Objects in the Drawing
- Lesson: Changing an Object's Position
- Lesson: Creating New Objects from Existing Objects
- Lesson: Changing the Angle of an Object's Position
- Lesson: Creating a Mirror Image of Existing Objects
- Lesson: Creating Object Patterns
- Lesson: Changing an Object's Size
- Challenge Exercise: Grips
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
- Chapter 4: Drawing Organization and Inquiry Commands
- Chapter 5: Altering Objects
- Lesson: Trimming and Extending Objects to Defined Boundaries
- Lesson: Creating Parallel and Offset Geometry
- Lesson: Joining Objects
- Lesson: Breaking an Object into Two Objects
- Lesson: Applying a Radius Corner to Two Objects
- Lesson: Creating an Angled Corner Between Two Objects
- Lesson: Changing Part of an Object's Shape
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
346 ■ Chapter 4: Drawing Organization and Inquiry Commands
Practice Exercise: Obtaining Object Information
In this practice exercise, you draw each type of object
that you have learned: circle, arc, line, rectangle. You
also practice the List command and observe what
information is displayed for each unique object.
1.
Draw the following objects (any size):
■ Circle
■ Line
■ Arc
■ Rectangle
2.
To List each object separately:
■ Begin the List command.
■ Select the circle and press ENTER.
■ Observe the information listed in the
AutoCAD Text Window.
■ Press F2 to close the text window.
3.
Repeat the previous steps for each object
drawn.