User`s guide
Table Of Contents
- Introduction
- Chapter 1: Taking the AutoCAD Tour
- Chapter 2: Creating Basic Drawings
- Chapter 3: Manipulating Objects
- Lesson: Selecting Objects in the Drawing
- Lesson: Changing an Object's Position
- Lesson: Creating New Objects from Existing Objects
- Lesson: Changing the Angle of an Object's Position
- Lesson: Creating a Mirror Image of Existing Objects
- Lesson: Creating Object Patterns
- Lesson: Changing an Object's Size
- Challenge Exercise: Grips
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
- Chapter 4: Drawing Organization and Inquiry Commands
- Chapter 5: Altering Objects
- Lesson: Trimming and Extending Objects to Defined Boundaries
- Lesson: Creating Parallel and Offset Geometry
- Lesson: Joining Objects
- Lesson: Breaking an Object into Two Objects
- Lesson: Applying a Radius Corner to Two Objects
- Lesson: Creating an Angled Corner Between Two Objects
- Lesson: Changing Part of an Object's Shape
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
330 ■ Chapter 4: Drawing Organization and Inquiry Commands
13.
To complete this side view, it will no longer be
a section view. Modify the lines accordingly:
■ With the command line blank, select the
vertical line as indicated below.
■ Click the lower grip and use object tracking
to track the inside corner as indicated.
■ Press ESC to deselect the line and grips.
14.
To adjust the horizontal lines:
■ With the command line blank, select the
line that is indicated below.
■ Select the left grip and drag it to the newly
located endpoint of the vertical line.
■ Press ESC to deselect the line, then click
the other horizontal line that is indicated
below.
■ Select the right endpoint grip and drag
it so that the line is perpendicular to the
vertical line to its right.
15.
To delete the underlying line segment:
■ With the command line blank, use a
window to select the short line segment,
clicking from left to right.
■ Use the Erase command or press DELETE.