User`s guide
Table Of Contents
- Introduction
- Chapter 1: Taking the AutoCAD Tour
- Chapter 2: Creating Basic Drawings
- Chapter 3: Manipulating Objects
- Lesson: Selecting Objects in the Drawing
- Lesson: Changing an Object's Position
- Lesson: Creating New Objects from Existing Objects
- Lesson: Changing the Angle of an Object's Position
- Lesson: Creating a Mirror Image of Existing Objects
- Lesson: Creating Object Patterns
- Lesson: Changing an Object's Size
- Challenge Exercise: Grips
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
- Chapter 4: Drawing Organization and Inquiry Commands
- Chapter 5: Altering Objects
- Lesson: Trimming and Extending Objects to Defined Boundaries
- Lesson: Creating Parallel and Offset Geometry
- Lesson: Joining Objects
- Lesson: Breaking an Object into Two Objects
- Lesson: Applying a Radius Corner to Two Objects
- Lesson: Creating an Angled Corner Between Two Objects
- Lesson: Changing Part of an Object's Shape
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
Lesson: Using Linetypes ■ 329
11.
To change the linetype scale of the selected
line segments:
■ With the command line blank, select
the two short hidden line segments as
indicated below.
■ Right-click and select Properties.
■ In the Linetype scale field, enter .5
■ Press ENTER to apply this change to the
selected lines.
■ Click the X in the upper left corner of the
Properties dialog box to close it.
■ Press ESC to deselect the line segments.
■ Observe that the linetype scale changes to
the scale of the previously selected lines.
12.
To convert other lines to the HIDDEN layer:
■ With the command line blank, select the
hole details as indicated below.
■ In the Layer Control list, select the HIDDEN
layer.
■ Press ESC to deselect the lines and observe
the change.