User`s guide
Table Of Contents
- Introduction
- Chapter 1: Taking the AutoCAD Tour
- Chapter 2: Creating Basic Drawings
- Chapter 3: Manipulating Objects
- Lesson: Selecting Objects in the Drawing
- Lesson: Changing an Object's Position
- Lesson: Creating New Objects from Existing Objects
- Lesson: Changing the Angle of an Object's Position
- Lesson: Creating a Mirror Image of Existing Objects
- Lesson: Creating Object Patterns
- Lesson: Changing an Object's Size
- Challenge Exercise: Grips
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
- Chapter 4: Drawing Organization and Inquiry Commands
- Chapter 5: Altering Objects
- Lesson: Trimming and Extending Objects to Defined Boundaries
- Lesson: Creating Parallel and Offset Geometry
- Lesson: Joining Objects
- Lesson: Breaking an Object into Two Objects
- Lesson: Applying a Radius Corner to Two Objects
- Lesson: Creating an Angled Corner Between Two Objects
- Lesson: Changing Part of an Object's Shape
- Challenge Exercise: Architectural
- Challenge Exercise: Mechanical
- Chapter Summary
242 ■ Chapter 3: Manipulating Objects
12.
Use the Mirror and Copy grip modes to populate the next office area to the right:
■ Select all of the objects as shown in the following image.
■ Click any one of the available grips to select it.
■ Right-click. Click Mirror.
■ Right-click. Click Copy.
■ Right-click. Click Base Point.
■ Pick the midpoint of the outside wall section (1) between the doors for the base point.
■ Drag your cursor up at 90 degrees and pick point (2).
■ Press ENTER to complete the copy.
■ Press ESC to release your selection set.
13.
Continue to use grips, as time permits, to populate the remaining offices with furniture.
14.
Close all files without saving.