User`s guide

Lesson: Creating Basic Objects ■ 93
8. To redo the lines:
■ On the Quick Access toolbar, click Redo.
■ Notice that all of the lines removed with
the Undo command are returned.
9. To draw a line using object snaps:
Note: Object snaps are points on objects
which enable you to accurately position other
objects. They are covered in detail in another
lesson.
■ On the Home tab, click Draw panel > Line.
■ As you approach the endpoint of the line,
the endpoint object snap marker should
appear.
■ Click to select the endpoint of the line.
10. To draw a line perpendicular to the last:
■ Drag the cursor upward making sure that
the angle field displays 90 degrees.
■ Enter 100. Press ENTER.
11. To draw a line and correct a mistake using the
Undo command:
■ Drag the cursor to the right making sure
the angle field displays 0 degrees.
■ Enter 35. Press ENTER.
■ Right-click near your last point. Click Undo.
■ Because you are still in the Line command,
only the last line segment that you drew is
removed.
■ Drag the cursor to the right again, making
sure that the angle field displays 0 degrees.
■ Enter 25. Press ENTER.