Technical information

Viewing and Editing Sections | 183
Viewing and Editing Sections
Use the View/Edit Sections command to view and modify sections one-by-
one. The following illustrations show how sections are displayed when you
use the View/Edit Sections command.
The following command prompt is displayed when you use the View/Edit
Sections command. You can use the Next, Previous, and Station options to
move to a section you want to view or modify.
Edits that you make to individual cross sections with the View/Edit Sections
command are not overridden when you apply different cross section factors
to a range of sections with the Edit Design Control command. For example,
if you modify the superelevation of three cross sections, and then apply ditch
control to the entire range of sections, the superelevation changes you made
are not lost. However, if you modify the superelevation of three cross sections
and then apply superelevation parameters to the entire range of cross sec-
tions, the changes that you made to the three cross sections are overridden.
What you see using the View/Edit Sections command
Station 42+00 Station 42+50 Station 43+00