9

Bevel Modifier 563
Inter face
Parameters rollout
Capping group
Yo u c a n d e t e r m i n e w h e t h e r o r n o t t h e b e v e l e d
object is capped at either end w ith the check boxes
in the Capping group.
Start—Caps the end with the lowest local Z value
(bottom) of t he object. When tur ned off, the
bottom is open.
End—Caps the end with t he highest lo cal Z value
(top) of the object. When turned off, t he end is
left open.
Cap Type group
Two r adio buttons set the type of cap used.
MorphCreatescapfacessuitableformorphing.
Gri d—Creates cap faces in a grid pattern. This
cap type deforms an d renders better tha n morph
capping.
Sur f ace group
Controlsthesidecurvature,smoothing,and
mapping of the surface.
The first two r adio buttons set t he interp olation
method used between levels; a numeric field sets
the number of segments to interpolate.
Linear Si des—When active, segment interpolation
between levels follows a straight line.
Curved SidesWhen ac tive, segment interpolation
between levels follows a Bezier curve. For visible
curvature, use multiple segments with Curved
Sides.
Segments—S ets the number of intermediate
segments b etween each level.
Four-levelbevelswith1and2segments
Bevels with linear and curved sides