8

Sweep Modifier 845
Parameters rollo ut – Wide Flange
Lengt h—Cont rols the height of the vert ical web of
the wide flange section. Default=14.0.
Width—Controls the width of the horizontal
flanges crossing the sec tion. Default=8.0.
Thick ness—Controls the thickness of the web and
flanges. Default=0.5.
Co rner Radius—Controls the r adius of the four
interior corners between the vertical web and
horizont al flanges. Default=0.5.
Note: Be cautious when adjusting these settings.
There are no constraining relationships between
them. Therefore, it’s possible to s et a radius
(Corner Radius) that is greater than the length of
the web or width of the flanges.
Sweep Parameters rollout
Mirror On XZ Plane—When turned on, the section
is flipped vertically in relation to the spline to
which the Sweep modifier is applied. Default=off.
Left: The object shows the default state.
Right: The object has Mirror On XZ Plane turned on.
Mirror On XY Plane—When turned on, the section
is flipped horizontally in relation to the spline to
which the Sweep modifier is applied. Default=off.