8

844 Chapter 8: Modifiers
Radius—
Cont rols the exterior radius of the pipe
sect ion. Default=3.0.
Thick ness—Controls the thickness of the wa ll of
the pipe. Default=0.5.
Parameters rollout – Quarter-Round
Radius—Controls the radius of the quarter round
sect ion. Default=3.0.
Parameters rollout – Tee
Lengt h—Cont rols the height of the vert ical web of
the tee sec tion. Default=12.0.
Width—Controls the width of the flange crossing
the tee section. Default=6.0.
Thick ness—Controls the thickness of the web and
flange. Default=0.5.
Co rner Radius—Controls the r adius of the two
interior corners between the vertical web and
horizontal flange of the section. Default=0.5.
Note: Be cautious when adjusting these settings.
There are no constraining relationships between
them. Therefore, it’s possible to s et a radius
(Corner Radius) that is greater than the length of
the web or width of the flange.
Parameters rollout – Tube
Lengt h—Controls the height of the tube section.
Default=6.0.
Width—Controls the w idth of the tube sec tion.
Default=6.0.
Thickness—Controls the thickness of the walls of
the tube. Default=0.5.
Sync Corner Fillets—When turned on, Corner
Radius 1 controls the radius of both the interior
and exterior corners of the tube. It also maintains
the thickness of the s ection. Default=on.
Co rn er Radius 1—Controls the radius of all four
interior and exterior corners of the section.
Default=0.8.
If Sync Corner Fillets is turned off, Corner Radius
1 controls the radius of the four exterior corners
of the tube.
Co rn er Radius 2—Controls the r adius of the four
interior corners of the tube. Default=0.0.
Corner Radius 2 is only available w hen Sync
Corner Fillets is t urned off.
Note: Take care when adjusting these settings.
There are no constraining relationships between
them. Therefore, it’s possible to set an inside
radius(CornerRadius2)thatisgreaterthanthe
length and width of the sides.