8

Sweep Modifier 843
Edge R adii—
Controls the interior radius at the
outermost edges of the vertical and horizontal
legs. Default=0.0.
Note: Be cautious when adjusting these settings.
There are no constraining relationships between
them. Therefore, it’s possible to set an inside
radius(CornerRadius2)thatisgreaterthanthe
length or width of the legs of the angle.
Parameters rollout – Bar
Lengt h—Controls the heig ht of the bar section.
Default=6.0.
Width—Controls the width of the bar section.
Default=6.0.
Co rner Radius—Controls the radius of all four
corners of the section. Default=0.0.
Parameters rollout – Channel
Lengt h—Cont rols the height of the vert ical web of
the channel sect ion. Default=12.0.
Width—Controls the width of the top and bottom
horizontal legs of the channel section. Default=4.0.
Thickness—Controls the thickness of both legs of
the channel. Default=0.5.
Sync Corner Fillets—When on, Corner Radius 1
controls the radius of both the interior and exterior
corners between the vertical web and horizontal
legs. It also maintains the thickness of the section.
Default=off.
Co rn er Radius 1—Controls the exterior radius
between the vertical web and horizontal legs of the
channel. Default=0.0.
Co rn er Radius 2—Controls the interior radius
between the vertical web and horizontal legs of the
channel. Default=0.5.
Note: Be cautious w hen adjusting these settings.
There are no constraining relationships between
them. Therefore, it’s possible to set an inside
radius(CornerRadius2)thatisgreaterthanthe
length of the web or width of the legs.
Parameters rollout – Cylinder
Radius—Controls the radius of the cylinder
section. Default=3.0.
Parameters rollout – Half-Round
Radius—Controls the radius of the half round
section. Default=3.0.
Parameters rollout – Pipe