8

Edit Poly (Vertex) 637
Top: The original vertex selection
Center: Vertices chamfered
Bottom: Vertices chamfered with Open on
Chamfer S ettings—Opens the Chamfer Ver tices
dialog (page 1–1071)
, which lets you chamfer
ver t ices via interactive manipulation and toggle
the Open option.
If you click this button af ter performing a manual
chamfer, the same chamfer is performed on the
current selection as a preview and the dialog opens
w ith Chamfer Amount set to the amount of the
last manual chamfer.
Target Weld—Lets you select a vertex and weld it
to a target vertex. When positioned over a vertex,
the cursor changes to a + cursor. Click and move
the mouse and a dashed line appears from the
vertex with an arrow cursor at the other end of the
line. Position the cursor over a neighboring vertex
and when the + cursor appears again, click the
mouse. T he first vertex moves to the position of
the second, and the two are welded.
Co nnect—Creates new edges between pairs of
selected vertices.
Connectwillnotletthenewedgescross. For
example, if you select all four vertices of a
four-sided polygon and then click Connect, only
two of the vertices will connect. In this case, to
connect all four vertices with new edges, use
Cut .
R emov e I s ol a ted V ert i ces—Deletes all vertices that
don’t belong to any polygons.
Remove Unused Map Verts—Certain modeling
operations can leave unused (isolated) map
vertices that show up in the
Unwrap UVW editor
(page 1–878)
, but cannot be used for mapping.
You can use this button to delete these map vertices
automatically.