8

598 Chapter 8: Modifiers
Density —Controls the mesh density of a selected
panel. This value is applied as a multiplier of the
Main Parameters rollout > Density setting .You
may increase the density of a particular panel by
raising this value.
If Main Parameters rollout > A uto Mesh is off
when you change this value, go back to the Main
Parameters rollout and click Mesh It! to update
the mesh. For this reason, it is recommended that
youleaveAutoMeshon.Theonlytimeyoumight
want to turn off Auto Mesh is while creating the
seams at the Cur ves sub-object level. Re-meshing
can take some t ime, s o you might want to define a
number of seams before re-meshing.
Different Density settings applied to separate panels
Mat ID—Set the m aterial ID for the selec ted panel.
Usingthisoptionenablesyoutoassigndifferent
materials to select portions of the clothing.
Position group
Reset—Resets the posit ion of the selected panels
to their original locations (that is, the locations
immediately after Garment Maker was applied).
Reset All—Resets the position of all panels to their
original locations.
Deformation group
Most controls in this group are available only when
one or more panels are selected.