8

Garment Maker Modifier 593
be necessary to do so. Panel Position serves
primarily as a starting point for placing panels.
11. Cont inue selecting panels and placing them,
adjusting as necessary.
All panels placed with Panel Position. Note tha t sleeve
panels need to be rotated 90 degrees, and cuff panels
need to be rotated and moved to the wrists.
Inter face
The Garment Maker interface varies depending
on the current modifier stack level:
object (Main
Parameters) (page 1–593)
or one of the four
sub-object levels:
•
Curves (page 1–595)
• Panels (page 1–597)
• Seams (page 1–599)
Main Parameters rollout
The Main Parameters rollout is the first rollout
you see on the Modify panel once you apply the
Garment Maker modifier. This rollout comprises
mostly controls to create and adjust the mesh.
The remaining rollouts are available at the
sub-object levels.
Density —Adjusts the relative density of the mesh
(in other words, the number of t riangles per unit
area). Possible va lues range between 0.01 a nd 10.0.
A value of 10.0 creates a very dense mesh, while
0.01 creates a comparatively low-resolution mesh.
For b est results, use the lowest possible density
to achieve the desired result. This speeds up
simulation time and overall performance.
Left: Density=0.5
Right: Density=1.5