8

374 Chapter 5: Creating Geometry
Genera te Ma pping Coords—
Sets up the required
coordinates for applying mapped materials to the
object. Default=on.
Cylinder Parameters group
Provides parameters for the base and main
cylinder of the damper.
Base Dia—The diameter of the base, or "mount"
of the damper .
Height—The height of the base.
Main Dia—The diameter of t he main housing of
the damper.
Height—The height of the main housing.
Sides—Thenumberofsidesofboththebaseand
the main housing .
Fillet 1—Thesizeofthefilletontheloweredgeof
the main housing .
Fillet S egs—The number of segments for Fillet
1. The higher this setting, the rounder the fillet
profile appears.
Fillet 2—Thesizeofthefilletontheupperedgeof
the main housing.
Fillet S egs—The number of segments for Fillet
2.Thehigherthissetting,therounderthefillet
profile appears.
Inside Dia—Specifies the inside diameter of the
main housing, which is actually a tube r ather than
acylinder.
Smooth Cylinder —When on, smoothing is applied
to both the base and the main housing.
Piston Parameters group
Provides parameters for the piston of the damper.
Diameter—The diameter of the piston.
Height—The height of the piston.
Sides—Thenumberofsidesinthepiston.
Smooth P is ton—When on, smoothing is applied
to the piston.