8

Straight Stair 235
Pr ocedur es
To create straight stairs:
1.
In any viewport, drag to set the length. Release
the mouse button, then move the cursor and
click to set the width you want.
2. Movethecursorupordowntodefinetherise
of the stairs, and click to end.
3. Adjustthestairswiththeoptionsinthe
Parameters rollout.
Inter face
Parameters rollout > Type group
Open—Createsanopenriserstairasshownonthe
left of the illustration above.
Clo sed —Create s a closed riser stair as shown in the
center of the illustration above.
Box—Creates a stair with closed r isers and closed
str ingers on both sides as show n on the right of the
illustration above.
Generate Geometry group
Stringers—Createsstringersalongtheendsof
the treads of the stairs. To modify the stringers’
depth, width, offset and spr ing from the floor, see
Stringers rollout (page 1–236) .
Carriag e—Creates an inclined, notched beam
under the treads which supports the steps or add s
support between the stringers of the stairs. You
might also know this as a
carriage piece , ahorse ,or
a
rough string .See Carr iage rollout (p age 1–237)
to modify the p arameters.
Handrail—Createsleftandrighthandrails. See
Railings rollout (page 1–237) to modify the
handrails’ height, offset, number of segments, and
radius.
Rail Path—Createsleftandrightpathsyoucanuse
to install railings on the stairs. Se e
Stairs (page
1–226)
for the instructions on how to do this.
Layout group
Lengt h—Cont rols the length of the stairs.
Width—Controls the width of the stairs.
Rise group
3dsMaxkeepsoneRiseoptionlockedwhileyou
adjust the other two. To lock an option, you click a
push pin. To unlock an option you click a raised
push pin. 3ds Max locks the spinner value of the
parameterwiththedepressedpushpinandallows
the spinner values of the parameter with the raised
push pins to change.
Overall—Cont rols the height of the flight of stairs.
Riser Ht—Controls the height of the risers.