8

1044 Chapter 9: Sur face Modeling
When you activate Turn, the diagonals (page
3–1022)
become visible as dashed lines in
wireframeandedged-facesviews.InTurnmode,
click a diagonal to change its position. To exit Turn
mode, right-click in the viewport or click the Turn
button again.
Each diagonal has only two available positions
at any given time, so clicking a diagonal twice in
succession simply returns it to its ori ginal position.
But changing the position of a nearby diagonal
can make a different alternate position available
to a diagonal.
For more information on how to use Turn with
the enhanced Cut tool, see
this procedure (page
1–1035)
.
Edit Geom et ry rollout
Repeat Last—Repeats the most recently used
command.
For example, if you extr ude an edge, and want to
apply the same extrusion to several others, select
the others, and then click Repeat Last.
Note: Repeat Last does not repeat all operations.
For instance, it does not repeat transforms. To
determine which command will be repeated when
you click the button, check the button’s to oltip. If
no tooltip appears, nothing w i ll happen w hen it is
clicked.