2009

Next, adjust the control points of the lattice to drape over the table.
1 Zoom Extents All Selected.
2 On the Modify panel, in the stack display (below "Modifier List"), click
the FFD(cyl) item so it turns yellow. This means you've enabled direct
access to the FFD space warps control point sub-objects.
3 In the FFD Parameters rollout > Selection group, turn on All X. This lets
you select control points around the perimeter of the FFD cylinder.
4 In the Top viewport, use the
Select and Move tool on page 959 and
region-select the two visible control points of the two outer rings of
control points at the nine-o'clock position. (This is easier shown than
described. You can actually region-select any number of vertices in the
two outer concentric rings of vertices. Because All X is on, all control
points for the two rings will be selected.)
5
On the status bar, click the Selection Lock Toggle button to lock
the selection. In the Front viewport, drag the selected points halfway
down the height of the table.
6 Unlock the selection, and then region-select any control point in the
outer ring to select all points in the outer ring.
2770 | Chapter 14 Space Warps and Particle Systems