2009

Flipped Flips the waveform horizontally.
Period Sets the number of frames to complete one waveform pattern. Spinner
Value=float, 0.01 to 9,999,999
Duty Cycle For square waves only, specifies the percentage of time the square
wave is "on." Default=50, Spinner Value=float, 0 to 100
Amplitude Sets the height of the wave. Spinner Value=float, 0 to 9,999,999
Phase Sets the offset of the wave. Spinner Value=float, 0 to 1
Vertical Bias group
A waveform's output value can be altered by adjusting the Vertical Bias
parameter. Spinner Value=float, -9,999,999 to 9,999,999
Centered Centers the waveforms vertical bias about zero. For example, a 100
unit amplitude waveform would range from -100 to 100.
Auto > 0 Shifts the waveform above the zero line.
Auto < 0 Shifts the waveform below the zero line.
Manual Lets you set the waveform manually by adjusting the spinner.
Effect group
Each waveform has an Effect parameter, which can be one of the following:
Add Causes the current waveform's value to be added to the previous
waveform's output. This is the default.
Multiply Multiplies the previous waveform's output by this waveform's value.
Clamp Above Limits the previous waveform's output to be above this
waveform's value.
Clamp Below Limits the previous waveform's output to be below this
waveform's value.
Characteristic Graph
Characteristic Graph shows one of three displays, controlled by the radio
buttons below the display.
This Wave Shows the current waveform only, independent of all other
waveforms.
3268 | Chapter 15 Animation