2009

To view controller properties in Curve Editor:
Do one of the following:
■ Highlight the label for a parametric or compound controller, right-click
the label, and then choose Properties from the shortcut menu to display
the properties dialog.
The dialog title identifies the controller type, the item or object name, and
the parameter. For example: Noise Controller:-Box01\Position
■ Double-click the label.
You can also view global properties for some transform controllers in the
Motion panel. The same controls described above apply.
Controller properties can also be viewed from the
track bar on page 7531.
Right-click any key and choose Controller Properties.
Changing Controller Key Information
Some controllers interpolate between keys that you set on specific frames.
Such controllers are always single parameter controllers such as a Bezier Float
controller for Height or TCB for Rotation. These controllers use a Key Info
dialog that contains settings for one of more selected keys.
To view key information in the Curve Editor:
■ Right-click a key to display the Key Info dialog.
If more than one key is highlighted, Key Info displays common information
for all of the selected keys. Settings that contain values indicate values
common to all of the selected keys. Settings that are blank indicate values
that change from key to key.
Viewing key information in the Motion panel always displays the settings for
a single transform key.
To view key information for transform controllers in the Motion panel:
1 Select an object.
2 On the Motion panel, click Parameters, if it's not already active.
3 Click Position, Rotation, or Scale on the Parameters rollout.
If the transform controller uses keys, Key Info rollouts appear below the
Parameters rollout.
3106 | Chapter 15 Animation