2009
The General Settings rollout appears.
2 Make changes to the settings. See Interface, below.
To set individual lights:
1 On the Configuration rollout, choose All Lights. The Lights rollout
displays settings for all the scene lights (subject to the limit of 150 lights
described above). Alternatively, you can select the lights to adjust, and
then on the Configuration rollout choose Selected Lights.
TIP If you change the light selection, the Light Lister does not update
interactively. Click Refresh to update the list.
2 On the Lights rollout, change the settings for any light on the list. See
Interface, below.
Some changes show up immediately in the viewport.
Interface
Configuration rollout
Chooses which lights and controls to affect, and lets you update light settings.
All Lights The Lights rollout shows all lights in the scene (subject to the
150-light restriction, described above).
Selected Lights The Lights rollout shows only selected lights.
General Settings Displays the General Settings rollout.
Refresh Updates the list of lights to use the current light selection (if Selected
Lights is active) and current scene settings.
NOTE When the Light Lister needs to be updated, the Refresh button is highlighted
in yellow.
Using Lights | 5001