2009

incremented. You can enter a descriptive name for a new bulge angle, such
as Arm at 90.
By default, one Bulge Angle is created in the Figure mode pose when Physique
creates links. Only one additional bulge angle is needed to bulge the mesh.
You can create more bulge angles for further control, if you want.
Delete Bulge Angle Removes the current bulge angle from the selected
link.
You cannot delete the default bulge angle.
Influence The range of angles through which the bulge influences the skin.
Range =0 to 180. Default=90 degrees.
For example, if you’ve set a bulge angle for the joint at 90 degrees, an Influence
value of 40 means that the bulge effect begins to appear when the rotating
joint reaches 50 degrees (90 minus 40) or 130 degrees (90 plus 40).
Power Controls how smoothly or abruptly the bulge takes effect. At 0.0, the
bulge takes effect immediately, without interpolated easing. As values increase,
the bulge eases in gradually. A value of 10.0 will bulge the mesh abruptly
when the set angle is reached. Range=0 to 10.0. Default=2.5.
Weight Increases the effect of the current bulge angle relative to the effect of
any other bulges. Range=0.0 to 100.0. Default=1.0.
Cross Section Parameters group
Sections Sets the number of cross sections for the selected link.
Physique User Interface | 4745