2009

Bulge Angles panel
At the right of the Bulge Editor are two panels for setting parameters. Use the
Bulge Angles panel to change bulge settings for the currently active bulge
angle.
NOTE These parameters are the same as those in the Bulge Angle Parameters
group on the Bulge rollout at the Bulge sub-object level. Changing a value in one
location changes it in the other.
Bulge Angles Click to display the Bulge Angles panel.
Influence The range of angles through which the bulge influences the skin.
Range=0 to 180. Default=90 degrees.
For example, if you’ve set a bulge angle for the joint at 90 degrees, an Influence
value of 40 means that the bulge effect begins to appear when the rotating
joint reaches 50 degrees (90 minus 40) or 130 degrees (90 plus 40).
Power Controls how smoothly or abruptly the bulge takes effect.
At 0, the bulge takes effect immediately, without interpolated easing. As values
increase, the bulge eases in gradually. A value of 10 will bulge the mesh
abruptly when the set angle is reached. Range=0 to 10. Default=2.5.
Physique User Interface | 4699