2009

3 Select additional cross sections by doing one of the following:
Use Ctrl+click to add cross sections to the selection.
Drag a rectangular region in the Profile view. All cross sections that
the region surrounds or crosses are selected.
TIP Use Alt+click to remove a cross section from the selection.
To move cross sections along the link:
Moving a cross section repositions where on the mesh a bulge occurs.
1 Select the cross sections to move.
2 On the Bulge Editor toolbar, click Select And Translate CS.
TIP If you are moving a single cross section, you can skip step 1 and click
the cross section after you click Select And Translate CS Slice.
3 Drag left or right in the Profile view to move the cross section (or cross
sections) left or right.
NOTE You cannot move cross sections through each other.
To copy and paste cross sections:
1 Select the cross section to copy.
2 On the Bulge Editor toolbar, click Copy Selected CS.
3 Select a cross section to paste over.
4
On the Bulge Editor toolbar, click Paste Selected CS.
The cross section you pasted now has the shape of the cross section you
copied.
NOTE You can copy a cross section and paste it to a similar cross section on
another link. Create a bulge angle and an appropriate cross section on the
target link before pasting. If necessary, use Mirror Selected CS after pasting.
Physique User Interface | 4691