2009

Fixer parameters
Individual fixers display different parameters. These include:
■ Width Determines how much of the curve is affected around the
keyframe.
All the Fixers except for Remove Keys display this parameter.
■ Damping Determines how the fix is blended into the existing curve.
Changes how effective the fixer should be. A higher value, the more
dramatic the change. A damping value of 1.0 is normal behavior
All the Fixers except for Remove Keys display this parameter.
■ Delete Keys Allows for selective key removal based on Interval Width.
When Delete Keys is used, keys are removed only within the Interval Width.
When Delete Keys is not turned on, Remove Keys will remove the selected
keys without considering the Interval Width.
This parameter is available only when Remove Keys is the fixer.
■ Interval Width Determines the number of frames around the error to
consider when deleting keys.
This parameter is available only when Remove Keys is the fixer.
■ Knee Angle Sets the rotation angle to determine what constitutes knee
extension errors.
If the knee is planted and its angle is less than or equal to the knee limit
angle, then the center-of-mass object is adjusted so that the knee angle
doesn't exceed the limit.
This parameter is available only when Knee Extension is the fixer.
■ Frames Determines the interval to consider for fluctuation evaluation.
This parameter is available only when Knee Wobble is the fixer.
■ Fluctuation Establishes the amount of change allowed before knee wobble
is identified.
This parameter is available only when Knee Wobble is the fixer.
If the knee angle fluctuates greater than the fluctuation threshold for 2
knee angles within the frame interval threshold, then the knee's angle is
changed, so that the wobble is eliminated.
Fix Selected Applies the Fixer operation to the selection in the Analyze Results
error list.
Fix All Applies the Fixer operation to all the errors, whether they are selected
in the Analyze Results error list, or not.
4502 | Chapter 17 character studio