2009

Stride Width=1 and Stride Width=3
Actual Stride Width Sets the stride width in modeling units. Changes to this
setting automatically change the Parametric Stride Width.
Timing
Auto Timing Sets timing parameters automatically.
Auto Timing affects the following timing parameters for the Jump gait:
■ 2 Feet Down, Airborne
When Auto Timing is selected, these parameters are automatically adjusted
to reasonable values. You control the footstep sequence by adjusting the
Stride Length and Time To Next Footstep parameters.
When Auto Timing is off, you can control the footstep sequence by
adjusting the gait timing parameters, but you can't change the Time To
Next Footstep parameter.
Interpolate Allows you to control acceleration or deceleration of the series
of footsteps. When this box is selected, a second set of step parameters under
Last Step is enabled.
Biped creates the footsteps starting with the values of the parameters under
First Step and ending with the values of the parameters under Last Step.
By interpolating between the two, Biped produces a footstep series that changes
over time.
When Interpolate is cleared, the Last Step parameters are grayed out. Biped
creates all the footsteps using only the parameters under First Step.
Start After Last Footstep Appends the newly created footsteps to the end of
the existing footstep sequence.
4452 | Chapter 17 character studio