2009
Create Multiple Footsteps Dialog: Walk on page 4441
Create Multiple Footsteps Dialog: Run on page 4447
Create Multiple Footsteps Dialog: Jump on page 4451
Walk: Sets the biped gait to Walk. Any footsteps you add will have walk
characteristics until you change to another mode (run or jump). Each new
footstep will start before the end of the previous footstep on the opposite side.
Run Sets the biped gait to Run. Any footsteps you add will have run
characteristics until you change to another mode (walk or jump). Each new
footstep will start after the end of the previous footstep on the opposite side.
Jump Sets the biped gait to Jump. Any footsteps you add will have jump
characteristics until you change to another mode (walk or run). Each new
footstep will start at the same time as the most recent footstep on the opposite
side. Alternately, it may start after the end of the previous footstep.
Timing parameters
Use these parameters with Create Footsteps (append) or Create Footsteps (at
current frame) to apply timing to newly created footsteps. These parameters
are different for each gait and change as you select a different gait.
Walk Footstep (Walk only): Specifies the number of frames a new footstep
will be on the ground during a walk.
Double Support (Walk only): Specifies the number of frames when both feet
will be on the ground at the same time during a walk.
Run Footstep (Run only): Specifies the number of frames a new footstep will
be on the ground during a run.
Airborne (Run and jump only): Specifies the number of frames when the body
will be in the air during a run or a jump.
2 Feet Down (Jump only): Specifies the number of frames when two sequential
footsteps, on opposite sides, will be on the ground during a jump.
Biped User Interface | 4437