2009

Bend Links Rollout
Select the biped > Motion panel > Bend Links rollout
This toolset combines the Bend Links Mode, previously located on the Biped
rollout, with other tools to allow an easier control over a chain link, such as
a biped spine, neck or tail.
NOTE Activating one of the Bend Links rollout modes deactivates any of the others.
However, clicking Zero Twist or Zero All maintain any mode currently active.
NOTE The Bend Links rollout is displayed in Mixer Mode, Motion Flow Mode or
Footstep Modes.
Procedures
To bend a spine naturally using Bend Links Mode:
1 Select any link in the biped's spine.
Biped User Interface | 4363