2009

Procedures
Example: To Add and Edit Twist Poses:
This procedure takes into account the concept of adding
twist links on page
4430 to biped limbs and concentrates on using the tools from the Twist Poses
rollout to set up basic poses.
1 Prepare a biped with five twist links on each upper arm.
TIP You can use See-Through on page 183 on the biped's limbs to better
distinguish the twist links inside.
2 Exit Figure Mode, and then expand the Twist Poses rollout.
3 Select the right upper arm.
The rollout controls are enabled because you selected a three-DOF limb.
4
Use Previous Key and Next Key to cycle through the different pose
presets.
Biped User Interface | 4359