2009

NOTE The icons position has no effect on the constraints behavior.
To assign a Rigid Body Collection to the solver:
1 On the Properties rollout click the RB Collection button.
This enters a pick mode in which you can choose only a Rigid Body
Collection.
2 In one of the viewports click the collection to assign to the Constraint
Solver. The collection should contain the rigid bodies for the constraints
in the solver.
To add constraints to a solver:
1 Create a Constraint Solver and some cooperative constraints to add to
the solver.
2 Add constraints to the solver using either (or both) of these methods:
On the Constraint Solver > Properties rollout, click the Pick button,
and then in the viewport click a constraint helper to add.
On the Properties rollout, click the Add button, and then use the
dialog to specify one or more constraints to add.
3946 | Chapter 16 reactor