2009
Procedures
To review and correct tracking errors:
1 Select an error in the list.
2 Browse through the errors in sequence by repeatedly clicking Next, under
the list.
3 When you’ve selected an error, the associated tracker gizmo is selected
and brought into view and the movie is set to the frame at which the
potential error was detected.
4 If there is indeed an error, adjust the gizmo in the Movie window to
correct it, and place a new keyframe.
5 If inspection shows that there isn't an error, the thresholds may be set
too finely, so try adjusting the associated threshold and running Check
Status again. This is often a good way to calibrate the thresholds for your
scene, but be careful not to increase them too much and miss a real error.
6 To clear an entry out of the list, click the Clear button. This is basically
a cosmetic action that removes items from the list that you've either fixed
or determined are not errors while working through the potential errors.
If you perform a Check Status again, some of the errors may show up as
well.
Camera Tracker Utility | 3839