2008

To align the input image, do one of the following in the Image Input Options
dialog:
1 Choose Presets and then click one of the preset alignment buttons.
2 Choose Coordinates and then enter the X,Y coordinates for the image's
location.
The upper-left corner is (0,0) for both the input image and the output
frame. Increasing X moves the image to the right, and increasing Y moves
the image down. Negative values move the image in the opposite
direction. X and Y values specify pixels.
To set the input image size, do one of the following in the Image Input
Options dialog:
1 Choose Do Not Resize to maintain the image's original resolution.
2 Choose Resize To Fit to change the image size to match the output frame.
This can change the image resolution, causing it to be rescaled for every
frame.
3 Choose Custom Size and then enter the width and height of the image
in the output frame.
To control playback of an animated image:
1 In the Frames group of the
Image Input Options dialog on page 6617 , set
the input animation frame range and speed.
2 Turn on Loop At The End if you want the animation to repeat. Turn off
Loop At The End if you want the animation to stop after playback.
This option applies only when the input animation is shorter than the
final video.
Interface
The Add Image Input Event and Edit Image Input Event dialogs have the same
controls.
Add Image Input Event | 6615