2008

Make sure that all the plug-in DLLs used in a job reside on each of the servers
rendering the job.
ERR: Job not found. Ok if just deleted
When you delete a job, the Manager sends out a notification to all clients
(Monitors) telling that the job has changed. This is the same message sent
when the job completes, gets suspended, resumed, etc. The monitors in turn
request the job status from the manager. The manager doesn’t find the job (it
was just deleted) and returns this error to the monitor.
ERR: Targa - The device is not ready. (0x15)
ERR: Frame error
The server could not write the output file. "Targa" represents the file output
type, and will change depending on the output file type you selected. This
problem can occur for several reasons:- If you are running the Backburner
Server as an installed Windows 2000/XP service, make sure that the user
account that the service is logged to has adequate permissions. Administrative
permissions are recommended.
■ Check to make sure the target output directory is shared, with both read
and write permissions.
■ Verify that the path for saving file output in the Render Scene dialog is set
to a valid UNC path name.
■ Verify that the path for saving file output in the Render Scene dialog (or
the Output Event dialog in Video Post) is set to a valid UNC path name.
■ If you are writing to a shared directory mounted locally on each server,
verify that the directory is mounted to the same drive letter on each server,
and that the file output path is set for that drive letter.
PROBLEM:The Server fails to render a frame and displays the
following error:
Rebooting 3ds Max by force due to load timeout.
SUGGESTION
The Server has exceeded either the Wait For 3ds Max To Load or Wait For 3ds
Max To Render value. This is usually caused by attempting to render large
files over the network. Increase these values in the
Advanced Settings dialog
on page 6296 .
6256 | Chapter 18 Rendering