8

794 Chapter 21: User Interface
The buttons on this flyout replace the Zoom button
whenaLightviewportisactive.
See also
Dolly C amera, Target, or Both (page 3–788)
Procedure
To dolly a light:
1.
Activate a Light viewport.
2. Click Dolly Light.
The button highlights when it is on.
3. Drag to move the light.
•Draguptomovethelightforwardalongits
line of sight.
• Drag down to move the light backward
along its line of sight.
4. Press ESC or right-click to t urn off the button.
Inter face
TheDollyLightflyoutconsistsofthe
following buttons:
Dolly Light—Moves only the light to and from
its target. If you go past the target, the lig ht flips
180degreesandmovesawayfromitstarget.
Dolly Ta rget—Moves only the target to and
fromthelight.Youseenovisualchangeinthelight
viewport, unless you dolly the target to where it
passes through the light to the other side, at which
pointthelightviewisreversed.However,changing
therelativepositionofthetargettothelightaffects
other adjustments, such as Orbit Li ght, w hich uses
the target as its rotational pivot.
This option is available only if the viewport’s light
is a target light.
Dolly Light + Target—Moves both the target
and the light to and from the light.
This option is available only if the viewport’s light
is a target light.
Li ght Hots pot
Activate a Light viewport. > Viewport navigation controls
>LightHotspot
Light Hotspot lets you adjust the angle of a light’s
hotspot (page 3–1048) .Thisbuttonreplacesthe
ZoomAllbuttonwhenalightviewportisactive.
The flo odlight has a narrow hotspot but a wide falloff area.