9

Bezier Controllers 311
2.
OntheMotionpanel,intheKeyInfo
(Advanced) rollout, click Norma lize Time.
Thekeyismovedintimetoaveragethevelocity
through the key.
Inter face
Motion p anel > Parameters > Key In fo (Basic)
rollout
A Key Info dialog w ith identical p ar ameters to this
rollout is available by right-clicking a key in Track
View or the track bar.
Key number—Shows the current key number. Click
the right or left arrows to go to the next or previous
key.
Time—Specifies when in time the key occurs.
Time Lock —Controls dragging the key horizontally
in Track View edit modes.
X/Y /Z—Adjusts the position of the selected object
at the current key.
Key Tangent—Two f lyouts set the i nter p ol at ion
properties of the in tangent and out tangent of the
key.
Choosing B ezier Tangent Types—Sets the tangent
types for one or more keys in the same track using
the In and Out tangent flyouts.
See Tangent Types (page 2–305) for detailed
information on each of the avai lable tangent
choices.
Tangent Copy—Copies the tangent type between
the tangent s of the current key or between the
tangents of the previous and next key. Use the
arrow buttons on either side of the Key Tangent
flyouts.
TheleftarrowoftheIntangentcopiestotheOut
tangent of the previous key.
The right arrow of the In tangent copies to the Out
tangent of the current key.
TheleftarrowoftheOuttangentcopiestotheIn
tangent of the current key.
TherightarrowoftheOuttangentcopiestotheIn
tangent of the next key.
Choos in g Bez i er Tangen t Typ es—Sets the tangent
types for one or more keys in the same track using
the In and Out tangent flyouts.
Bezier S cale Controller (Lock X)—Causes the X value
to affect all three axes of scale. The Y and Z values
are ignored and their function curves ar e not
displayed.
When X is locked, the Y and Z values are not
affected by changes in the X value. If you lock X
when all three axes are at ident ical values, alter the
X va lue, and then unlock X, the Y and Z values
remain w here they were while X retains its new
value.