9

Ink ’n Paint Material 1609
Mapping the Lighted component
Right rear: The o riginal, unmapped material
Left: Lighted component with a falloff map applied
Right front: Lighted component with a bitmap applied
• Map check box—The check box between the
spinner and the button enables or disables the
map. Default=off until a map is assigned, then
on.
•
Ma p button—Click the button to assign a m ap
to this component.
While a map is assigned and enabled, at 100
percent it completely overrides the main color
component. At lower percen tages, the map is
blended with the color.
Ink Controls rollout
Ink is the linework, the outlines, in the material.
Except for Ink Width, each of the ink components
hasanon/offtoggleandacolorswatch. Click
the color swatch to display a ColorSelector(page
1–161) and change the ink component’s color.
Each ink component, Ink Width included, also has
a set of map con trols.
Ink—When on, the rendering is “in ked.” When off,
no ink lines appear. Default=on.