9

Filters Panel 1023
center-of-mass object is adjusted so that the
knee angle doesn’t exceed the limit.
This parameter is available only when Knee
Extension is the fixer.
•
Fr ames— Determines the inter va l to consider
for fluctuation evaluation.
This parameter is available only when Knee
Wobble is the fixer.
•
Flu ctu at i on — Establishes the amount of change
allowedbeforekneewobbleisidentified.
This parameter is available only when Knee
Wobble is the fixer.
If the knee angle fluctuates greater than
the fluctuation threshold for 2 knee angles
within the frame interv al threshold, t hen the
knee’s angle i s changed, so t hat the wobble is
eliminated.
Fix Sel ected—Applies the Fixer operation to the
selectionintheAnalyzeResultserrorlist.
Fix All—Applies the Fixer operation to all the
errors, whether they are selected in the Analyze
Results error list, or not.
Fil ter s Pa nel
Select a biped par t. > Motion panel > Biped Apps >
Workben ch > Filters panel
Filters are simply operations that can b e per formed
to different biped bo dy parts. They are similar to
fixers, but they operate over an interval of time
rather than the results of the last analysis. Thus you
canuseafilterwithoutanalyzing.Certainfilters
share parameter types and functionality as fixers,
though the values are not shared and are distinct
for each filter. Use a filter whenever you want to
perform a general operation over a body parts
motion, like smooth out or boost up some noise."
Procedure
To filter a track:
1.
Choose the p arts you want to filter: either just a
particular curve, or an entire selection.
2. Choosethetimerangeyouwanttofilter:either
theentirebipedanimation,theactivetime
segment, or a custom range.
3. Choose the filter you want to apply. Adjust its
individual param eter as required.
4. Click Filter at the bottom of the panel.
5. ObservetheeffectonthegraphintheCurve
view.
6. Play the animation in the viewport and observe
the difference, if any.
Click Undo if the results are unexpected or
incorrect.