8

Bulge Editor 973
Note:
These parameters are the same as those in
the Cross Section Parameters group on the Bulge
rolloutattheBulgesub-objectlevel.Changinga
value in one location changes it in the other.
Cross Sections—Click to display the Cross
Sections panel.
Sections—Sets the number of cross sec tions for t he
selected link .
Tip: Rather than manually insert ing cross sections
inProfileview,useSectionstocreatecross
sections. For a thigh or biceps bulge, you might
need only one additional cross section in the
middle of the link.
Above: S ections=1
Below: Sections=8
Divisions—Sets the number of control points on
the selected cross sections. By default, cont rol
points are evenly distributed around the cross
section control spline.
Above: Divisions=4
Below: Divisions=8
Resolution—Sets the number of radial divisions
around the cross section. Control points snap to
the nearest resolution line.
Entire Link —When on, selects al l cross sec tions for
all bulge ang les in the selected link. Use this to
globally change parameters for al l cross sections
on a link.
Entire Link also affects Copy Selected CS and
PasteSelectedCS.WhileEntireLinkison,Copy
Selected CS copies all cross sections for a ll bulges,
and Paste Selected CS pastes all cross sections for
all bulges. Entire Link is useful for copying all the
bulges from one arm or leg to another.
Note: When you turn on Entire Link, a number
of toolbar controls, including the Current Bulge
Anglenamefield,becomeunavailable. Onthe
Bulge rollout at the Bulge sub-object level, the
Current Bulge Angle change s to read “Entire Link.”