8

Barycentric Morph Controller Key Info Dialog 371
Bar ycentric Morph Controller K ey
Info Dialog
Select a Morph object > Main toolbar > Curve Editor
(Open) > Right-click over a Morph key in the Dope Sheet.
> Barycentric Morph Controller Key Info dialog
GraphEditors>TrackView–CurveEditor>OpenTrack
View > Right-click over a Morph key in the Dope Sheet. >
Bar ycentric Morph Controller Key Info dialog
You can change morph t arget weighting using
controls in the Barycentric Morph Controller Key
Info dialog.
Inter face
Curr ent K ey —Specifies the current key that you’re
adjusting.
Time—Specifies where, in time, the current key is
placed.
Tension/Continuity/B ias—Adjusts the TCB
parameters of the key spline interpolation.
TCB Spline—Displays the key interpolation spline.
Targets—Lists all morph targets for the object,
along with the percentage of their influence at the
current key. The total percentage of a ll targets
is displayed below the window. You can select
any t arget in this w indow, and then adjust its
percentage of influence u sing the spinner at right.
Percentage—Sets the p ercentage of influence for
the target selected in the list window. Percentage
values can be negative as well as greater tha n 100
percent.
Constrain to 100% —Limits total weight of all
targets to 100 percent. As you increase or decrease
thepercentageofaselectedtarget,theothertargets
adjustaccordingly.Theadjustmenttakestheform
of bala ncing all of the target percentages so that
their relative weights remain the same.
When this check box is turned off, you can adjust
theweightofeachtargetwithoutaffectingthe
others, and create a total that’s g reater or less than
100 percent. Totals greater than 100 percent c ause
themorphobjecttoscaleupinsize,whiletotals
less than 100 percent cause the mor ph object to
scale down. Note that this check box is global, and
not confined to a single key or track.