8

1478 Chapter 16: Material Editor, Materials, and Maps
To replace a color:
1.
Click a color swatch labeled Color #1 or Color
#2.
2. In the standard Color Selector (page 1–157) ,
choose a r eplacement color.
The color updates in the color box and sample
slot.
To swap a color:
•ClickSwap.
The position of the two colors is reversed in the
color boxes and sample slot.
To replace a color with a map:
1.
Click a Map bar marked None next to one of
the color swatches.
The Material/Map Browser is displayed.
2. Select a map from the l ist.
Thesampleslotupdatestoshowthemapin
place of the color.
Inter face
Size—Setstherelativesizeofdents. Asthesize
increases, the nu mb er of dents decreases when
other sett ings are the same. Default=200.
Decreasing Size creates the appearance of tiny
dents spaced fairly evenly. The effect can resemble
a "sand-covered" surface.
Increasing Size creates the appearance of distinct
grooves and gouges on a surface. The effect
sometimes has a "hardened lava" look.
Size=10, 500, and 1000
Iterations=1, Strength=20 (default)
Size=10, 500, and 1000
Iterations=3, Strength=20 (default)
Each set of three spheres uses the same size range,
but varies the number of iterations. Strength is
held constant in both sets.
Strength—Higher values increase the number of
dents, lower values decrease the number of dents.
Default=20.
Decreasing Strength reduces the number of dents
over a surface. At 0, the surface is smooth (no
dents).
Increasing Strength increases the number of dents
over a sur face. 100 is maximum.
Strength=5, 20 (default), and 100
Size=10, Iterations=3