8

Tiles Map 1471
by default to the vertical gap, so that both values
change as you edit one or the other. To unlock
them, click the lock icon.
Vertical Gap—Controlstheverticalsizeofthegrout
between the ti les. This value is locked by default to
the horizontal gap, so that both values change as
you edit one or the other . To unlock them, click
the lo ck icon.
%Holes—Sets the percentage of holes in the tiled
surface caused by missing tiles. The grout shows
through the holes.
Rough—Controls the roughness of the edges of the
grout.
Miscellaneous group
Random Seed—Randomlyappliespatternsofcolor
variation to the tiles. Does not require any other
setting to generate completely different patterns.
Swap Tex ture Entries—Swaps the texture maps or
colors between the tiles and the grout.
Stacking Layout group
Note: This group of controls is active only when
CustomTilesisselectedinStandardControls
rollout > Pattern Setup > Preset Type.
Line S hift—Shifts every second row of tiles a
distance of one unit.
Random Shift—Randomly shifts all rows of tiles
a distance of one unit.
Row and Column Editing group
Note: This group of controls is enabled only when
CustomTilesisselectedinStandardControls
rollout > Pattern Setup > Preset Type.
Row Modify—When on, creates a custom pattern
for rows, based on the values of Per Row and
Change. Default=off.
•
Per Row—Specifies which rows to change.
When Per Row equals 0, no rows change. When
Per Row equals 1, every row changes. When
Per Row is a value greater than 1, the change
appears every
N rows: a value of 2 changes
every second row, a value of three changes
every third row, and so on. Default=2.
•
Chan g e—Changes the w idth of tiles in the
affectedrows.Avalueof1.0isthedefaulttile
w idth. Values greater than 1.0 increase the
w idth of ti les, and values less than 1.0 decrease
it. Range=0.0 to 5.0. Default=1.0.
A value of 0.0 is a special case: When the
Change value is 0.0, no tiles appears in that row,
and the underly ing material shows through.
Co lumn Modify—When on, creates a custom
pattern for columns, based on the va lues of Per
Column and Change. D efault=off.
•
Per Col umn—Specifies which columns to
change. When Per Column equals 0, no
columnschange.WhenPerColumnequals1,
every column changes. When Per Column is a
valuegreaterthan1,thechangeappearsevery
N colum ns: a value of 2 changes every second
column, a value of three changes every third
column and so on. Default=2.
•
Chan g e—Changes the height of tiles in the
affected columns. A value of 1.0 is the default
tile height. Values greater than 1.0 increase the
height of t i les, and values less than 1.0 decrease
it. Range=0.0 to 5.0. Default=1.0.
A value of 0.0 is a special case: When the
Change v alue is 0.0, no tile appears in that
column, and the underlying material shows
through.